How do I pair my SSE smart meter?

How do I pair my SSE smart meter?

  1. Take your In-Home Display to where your electricity meter is located.
  2. Once you’re close to the meter, hold down the “OK button” until the In-Home Display turns off and then on again.
  3. You should then see the message: “your smart meter is now paired”.

How do I reconnect my smart meter to IHD?

Try moving your In-Home Display closer to your electricity smart meter. Once you’re there, turn it off using the round, flat button at the back. Wait a minute and then press the button again to switch the IHD back on. Sometimes, this gives it the boost it needs to get going again.

Why is my smart meter not connecting?

To restore the lost connection to your smart meter, you’ll need to: Take your In-Home Display to where your electricity meter is located. Once you’re close to the meter, hold down the “OK button” until the In-Home Display turns off and then on again. You should then see the message: “your smart meter is now paired”.

How do I reset my smart meter?

To reset it it turn it right off by holding down the power button for 10 seconds and then power it back on again, it should work.

How do I reset my smart meter at home?

Unplug your in- home smart meter display if your display isn’t updating. For five seconds, hold the power button. Plug the display back in and then switch it on.

How do I reset my IHD smart meter?

  1. Unplug the IHD and let it run out of power completely.
  2. Leaving the IHD unplugged, restart it by pressing the round, flat button on the back.
  3. Let the emergency power reserve run out completely.
  4. Plug the IHD in to recharge it, then switch it back on.

Where is the reset button on a smart meter?

How do I reconnect my smart meter to WIFI?

Leave a Reply

Your email address will not be published.